My reactions upon receiving the model were the same as yours Lief.
I was unable to put on part #11-A because I glued the Pilot's seat back to the dividing bulkhead. If you only glue the seat to the floor, then you can install #11-A at the stage shown, otherwise you should do it after the bulkhed is installed. Also, the mating part to 11-A is identified as part #9 on the parts sheet. It should be part #11.
Because I was unable to install #11-A, I painted this area the same color as the rest of the cockpit. Looks fine to me.
Last edited by Bluenoser; 02-19-2008 at 11:38 AM.
|