Now, let's finish the wing by putting the elements of the wing root.
These are the pieces of the air intake that go on the wing root.
I started the wing root. Inside this piece is the structure that was already built.
This piece on the right of the picture is rather difficult to place. When gluing it, it seem that something was missing to close the gap to the other piece... but it was that it has to be bend enough so it can close it to the left. Remember the special gull wing form, this keep our neurons working-out to sweat.
So it goes.
Let's close the set with the next piece.
Now I glue the wing to its root applying another very good amount of glue.
Now I glue the support piece to the fuselage.
Now, to attach the wing. This is the starboard wing, because I didn't photographed the port wing when I did it. It works the same for our report.
Now, an overview of the plane.