With continuation of contest until end of october, I started another Zio's models.
The first is a very difficult Breda 65. I study the builds of Don Boose and Cjwalas, and my book from Ali D'Italia about this plane and I believe found the solution...
I started from the fuse, I use one tab only for my glues... The important step, in wing root I made a fold line with old blade, in a curvature airfoil...
After the preparation and coloring edges I glue all fuselage...
Next I building the bottom of wing, note the double curve I obtain with a wire tool front in my hand...
The next I made wings and glue in wing roots with careful..
Is the result at the moment but not worry...
The secret is glue bottom of wing first rear section, rest dry and glue with carefull inferior face of wing, the Breda is a minor gull arrange in inferior wing root. In the kit this featured is very pronounced, is a mistake of design I believe, but fit the dihedral problem...
After adjusted with round tool and hand the result is...
The rest is easy.
Last note: before building wings i build the rudder to made a strong build in fuselage.
Continue tomorrow!
Regards my friends!