View Single Post
Old 01-25-2012, 11:21 AM
cMags's Avatar
cMags cMags is offline
Join Date: Jan 2009
Location: Lowell, MA
Posts: 2,038
Total Downloaded: 36.65 MB
Send a message via AIM to cMags

I start this build beginning with the framework / skeleton for the fuselage, as per the first page of diagrams. This will be the first model I've built that uses this skin-over-framework construction method. At this scale, I printed the framework onto 110lb cardstock, which is not quite as thick as the slots in the framework, but should be more than strong enough once assembled. For the lengthwise pieces, I laminated this 110lb stock to a 65lb card sheet, which brings the thickness to the right dimension, but it's difficult to cut out, so I'm only doing so on certain parts.

Off to a good start:

Put on hold build (someday I'll finish): F-35A Lightning II 1:72
Previous builds: cMags' Card Model Builds
Reply With Quote