The basic hangar assembly is composed of 3 parts: the aircraft track (#64), the inner (printed) hangar liner (#63) and the outer hangar cover (#62).
The aircraft track (64) needs to be laminated to a piece of 1.0 mm cardboard.
The
inner hangar liner (63) needs to be smoothly rolled into a tube of diameter 21 mm. PUT THE JOINT TO THE TOP!! The outer hangar shell (62) needs to be rolled into a tube of diameter 23 mm. PUT THE JOINT of 62 TO THE BOTTOM!! I used steam,dowels,an old shower curtain rod and patience to roll these tubes....
MTF
Jim