View Single Post
 
Old 11-27-2008, 09:50 AM
redhorse's Avatar
redhorse redhorse is offline
Member
 
Join Date: Mar 2008
Location: McKinney, TX
Posts: 1,926
Total Downloaded: 0
Now here is the hull plating, I'm not too displeased for my first attempt. I think in the future I'm going to make the strips 8mm or so as there were a couple places where there was very little to glue onto. I worked towards the center from the bow and the stern and hoped the center piece was too big rather than too small. It was! So I trimmed it down and everything fit pretty well. The stern pieces did need some minor adjustment and also the shrike rollystyks came in very handy!
Attached Thumbnails
IJN Isuzu 1:200 - Answer-11-26-08-004.jpg   IJN Isuzu 1:200 - Answer-11-26-08-008.jpg   IJN Isuzu 1:200 - Answer-11-26-08-009.jpg   IJN Isuzu 1:200 - Answer-11-26-08-010.jpg   IJN Isuzu 1:200 - Answer-11-26-08-011.jpg  

IJN Isuzu 1:200 - Answer-11-26-08-012.jpg   IJN Isuzu 1:200 - Answer-11-26-08-013.jpg   IJN Isuzu 1:200 - Answer-11-26-08-014.jpg   IJN Isuzu 1:200 - Answer-11-26-08-015.jpg   IJN Isuzu 1:200 - Answer-11-26-08-016.jpg  

IJN Isuzu 1:200 - Answer-11-26-08-017.jpg   IJN Isuzu 1:200 - Answer-11-26-08-018.jpg  
__________________
Jim
Reply With Quote