Massive thanks for this! I already started building mine and I have some minor suggestions:
-the split on the hood would look better if it was in the middle (symmetry)
-the turbo bulge may be easier to assemble if it was unfolded like on the picture - on the other hand, some of the tabs would have to go, there's just no more place for them. This is more of a personal preference, I had to re-arrange it to be able to map the bird on the hood by hand
-tyre texture mapping - the pattern is running one way, then half-way it reverses direction (you can clearly see the split in bottom view)
By the way: would you be willing to share the 3d model? I'd like to experiment with the mesh a bit, add few more polys etc. when I'll have some time.