View Single Post
 
Old 04-05-2014, 12:04 AM
andersonmr34's Avatar
andersonmr34 andersonmr34 is online now
Member
 
Join Date: Feb 2014
Posts: 51
Total Downloaded: 161.92 MB
Let's see...how about the lasers and wings next!

The lasers were made up of three pieces each (it was kind of tedious). I left tabs on, and rolled them into cylinders. They were quite thin, you'll probably need something a good deal thinner than a pencil. I used a mircobrush handle and that seemed to work...

The wings were a simple box shape, so not a big deal...except for one thing... I had to do some "X-acto knife" surgery to cut out grooves for inner pair of lasers. Fortunately, there are grey stripes on the wings that are the right width and in the right position to aid in cutting in the right spot. Cut out those stripes and some half-circles on the sides and it should work out good! (the last picture of the wings is like a "before and after" kind of thing)
Attached Thumbnails
Pyro GX from Descent-img_1851.jpg   Pyro GX from Descent-img_1852.jpg   Pyro GX from Descent-img_1853.jpg   Pyro GX from Descent-img_1854.jpg   Pyro GX from Descent-img_1855.jpg  

Reply With Quote