yup. just my pointy exacto knife.
didn't even use a new blade.
you can see it in the first photos.
and a strong pair of reading glasses.
Took about three to four minutes to cut all the holes.
And I only fudged one spot, when I used a needle to poke
the small hole just below the larger hole in the upper left.
When pulling out the needle, it tore the bottom of the large hole.
Biggest mistake I made was cutting out the panel, and then cutting holes.
I recommend cutting the holes before you excise the panel from the sheet.
It gives you something more substantial to hang on to!
|