Hi,
Now it went to the second chimney ...
First, an overview of the components to be used.
(I know the picture is not exactly great but at least informative ....)
An incision was then made for the outer skin so that the skin disappears nicely behind the rounded bead.
Same time test whether the intermediate floor plate fits.
I have not only watched here .... because the plate must be rotated by 180 °.
But it was quickly corrected.
For the testing I removed the tap at the bottom so I could work better here ...
This reinforcement bead would not please me as a whole as this
Then most do not fit properly you look too much of the cutting edges ...
So I now have this solution which I consider on this scale as much better.
And with the file one should be able to deal as a model builder.
Alternatively, you can also take a minimot with the blue silicone sanding discs
work's also very good ....
Here I have one of the cooling ribs sheet (or whatever that may be called) as a passport times arched and applied ...
This was glued on the inside and outside with seconds adhesive ....
Look at the connectors ...
And the inner chimney structure had to be primed
The chimney is positioned with the help of these connectors and already something in "form"
Brought about. The downward protruding connectors are then glued with a second adhesive.
Regards
Martin