View Single Post
 
Old 01-31-2017, 11:06 AM
ShadowCory's Avatar
ShadowCory ShadowCory is offline
Member
 
Join Date: Aug 2016
Location: Florida
Posts: 877
Total Downloaded: 29.59 MB
Quote:
Originally Posted by rmks2000 View Post
Congratulations on building the plotter. It is quite an accomplishment. I thought of doing the same with an old printer a four or five years but never got the time to do it and eventually junked the printer.
Quote:
Originally Posted by Kugelfang View Post
Very cool! Re-purposing obsolete printers never even crossed my mind. Hmmm...

--jeff
So far I only have about 45 USD in it. I don't for see spending much more. I replaced the dc motors in the printer with some really cheap stepper motors I ordered from amazon. It was $12 USD for 5 motors and little controller boards. The arduino was $15 USD. The kit with the breadboard, jumper wires, and servo motor was about $10 USD. I bought a couple of ac to dc power transformers from a thrift store for $1 usd. That's about it. Well, the swivel knife will be about $6 usd. So it is a very cheap plotter
__________________
My other life:http://rcorycollins.weebly.com/
Reply With Quote