|
Re: the Sentinel model...I just noticed that I did not add any note (on the model sheet)
about using the "optional hood detail" part.
I'm guessing its intended to represent an air intake for the engine.
Maybe like an air filter housing or something.
You can, for more 3D detail, cut out the circular thing in the hood.
Make sure to cut right to the edge of the black circle.
Then, cut out the extra circle thingy (or use the one you cut out of the hood)
and glue it on top of the larger black/gray disc thingy.
You can layer the circle thingy as much as you want
if you want it to stick up higher than the Hood.
Then cut out the whole thing and mount it...from underneath...at the hood opening.
|