View Single Post
 
Old 10-04-2017, 04:13 PM
Sygrod's Avatar
Sygrod Sygrod is offline
Member
 
Join Date: Aug 2008
Location: Stratford, ON
Posts: 220
Total Downloaded: 664.90 MB
Inspired by this thread, I printed out some US Navy planes, among which was a nice Helldiver. After putting some serious effort into the building, I found that the tail piece does not fit. The markings don't line up and the end that attaches to the mid section of the fuselage is too big. This is the aspect of building paper models that really kills it for me. I have a large number of non-finished models in my home, where I suddenly ran into a serious design mistake and a part did not fit.
Attached Thumbnails
NAVY & MILITARY Planes in 1/200-img_20171004_114811.jpg   NAVY & MILITARY Planes in 1/200-img_20171004_114819.jpg  
Reply With Quote