Parts 246 through 249 form the quad walls. They basically attach to the outside of 234 through 237 to create 2-sided printing. 247 and 248 have a small tapered box at the top that form attachment points for the Ascent Module later in the build.
I used Elmers All Purpose glue stick to attach parts 246 through 249. The 4 quads look very similar so I had to double-check each part before attaching to make sure they were the right ones.
Part 250 is the lower surface of the Descent Module assembly. There are a few folds to create 2-sided printing in the quads. There were a lot of detailed cutouts to prepare the part. I also added some gold foil wrapping paper to quad IV for more realistic finish.
Attaching 250 was a bit challenging. I used small pieces of tape to hold the part in position as I carefully glued it into position.
Part count to date: 479
|