Hi all
Well been at a little test fitting with a few parts.
Please keep in mind all the parts are at design stage and have only been printed in a cost saving draft mode for now, so quality of print is not good
I have worked out how the rear turret is going to be done, I think.
How I want to do it is build the front of the turret first with the gun and glass in it. Then add the rear of the turret like a shell over the back.
The photo with the yellow arrow shows which part has been worked out, I've even had a go at putting in the glass just to see how it would work.
Next stage with this now is to sort out the Browning guns and connecting tube between mounts.
Basically I was checking if the idea would work and most of all I could manage it.
As I'm not using any program to other than paint, its a case of everything needs to be checked and tested before I move on.
Next I will show how the engine pods are getting on
Regards
Rob