Hi
Back again if you can stand it.
As in previous post I will show the basics so far for the outboard engine pod.
This at the moment is how it would go together for a model with no engine in it. First I will finish this off just to check everything is ok. Then work out how to remove the formers and put a representation of a Merlin into the pod
that won't be easy.
The photos show what I have tested so far. This is from the leading edge to just before the spinner.
I rushed 2 of the formers when cutting them out, only noticed after I had glued them all up. I was just in from work, tired and to keen to get at it
my fault
The concept seems to be working up to now.
It will still need one more bit at the sinner end, exhaust ports and flame shields suppressors added as well.
The last photo shows the pod placed onto a loose folded section of wing.
Well enough for now if your still awake and not nodded off done
Take care
Rob