Quote:
Originally Posted by luke strawwalker
Exactly... I think the laminating is the problem... If you want to beef it up, cut another thicker card pattern and roll it separately and fit it INSIDE the cone AFTER the "outer skin" is done...
Later! OL J R: )
|
To answer both, i’ve Frequently laminated and rolled tubes with no problem, especially at this diameter. The printed stock seemed a little light so oi seemed the way to go.
I had considered rolling an inside cylinder and attaching after the outer was complete. I may do that with a combination of a circular support insert at either end.
If nothing else. I was able to locate sheets of the Cello-Mount double sided permanent adhesive the I’ve used successfully since 1979. I am going to order a sheet. Have printed out the new orange Rescue panels. Now will wait for Cello-Mount.
The capsule itself came out fine. And now that I’ve colored the edges I think it looks quire good.