continued.
The engine inlet cone is glued in place to the forward nacelle to match. The kit parts are a bit short in this location .
insert the forward half of the frame and glue and glue in place
The aft frame has to be cut a bit more ( in the center ) to allow it to be slipped in aft. Also the rear frames need to be cut back a bit around the exhaust area
both nacelles done
dry fit to the wings
I added 4 small card stock parts on the inside to support the glueing of the nacelles to the wings
glue the nacelles to the wing.
the aft area is ambiguous, however it will be covered by an aft fairing, so it makes no difference
both nacelles glued on
add the rear fairing
here is the forward fairing
aft fairing
and a view of the faired nacelle
lastly is to add the nose cone to the engine inlet
Isaac