Thread: Electra
View Single Post
 
Old 01-27-2019, 07:03 AM
Mike Stamper's Avatar
Mike Stamper Mike Stamper is offline
Member
 
Join Date: Jul 2007
Posts: 1,029
Total Downloaded: 45.93 MB
Electra

I decided to try another figure using Pepakura, I didn't realise there were different "levels" to the programme. This one was quite basic which sloed me down a bit.

I printed the parts on to 160g paper but for the face I used 80g paper. I also used a couple of wooden "kebab sticks" to strengthen the legs.

The model is about 16 inches tall including the homemade base. The fit of the parts was good but the hands were very intricate and the left hand page of the viewer was not much help - I had about four attempts trying to get them right.

I've tried to get the right view of the pictures without success, but clicking on them shows them the right way round.

Cheers
Mike
Attached Thumbnails
Electra-img_3142.jpg   Electra-img_3143.jpg   Electra-img_3144.jpg  
Reply With Quote