|
Don, if I may wade in here. I've got a copy of this model and on checking I'm not surprised you and gotham have hit a brick wall here. The circumference of both bulkhead 12a and radiator front 13a are more than the inside of part 12 if it's top edges were joined as the instructions indicate. Having said that, I notice there is no join tab for part 12 on the sheets.
In the absence of a response from Nobi, what I would do is make up a join tab for 12, glue it together, then trim down 12a to fit. Radiator front 13a can also be trimmed or, if not too far and out of scale, placed further back inside 12.
The reason I would try this is because from what I can see in the instructions, bulkhead 12a is supposed to butt up against bulkhead 7b. Unless my old eyes deceive me, the bottom edge shape of 12a does not match the lower edge shape of 7b. I think if you trim down 12a to match 7b then it stands a much better chance of slotting inside the back of part 12.
Hope you can follow the foregoing and I hope it helps.
Garry G.
__________________
''Oh, stop whining! Can't you just print off another one?''- my wife ca 2018
|