Patterns printed on regular copy paper and glued to 2 layers of Poster board card.
About 1mm thickness is what is needed.
Except for that bottom panel...its for a different part of the assembly
and needs to be one more layer of postercard (1.5mm).
...
Cut out the holes for dowels first.
I used a regular Hobby Knife for this.
Two sizes of holes...one is 8mm and the other is 6mm (or therabouts).
...
All the parts cut out and ready for assembly.
...
The assembled structure...fairly straightforward.
Note...the top and bottom plates were measured incorrectly.
I had to turn them 90degrees and recut the tabs, so I didn't have to make new parts.
I'll just make the adjustments to the parts on the computer.
...