As I stated, this is a scanned copy of the original kit I purchased back in the 70's.
after scanning as is, the parts are then printed on conventional 65 lbs card stock I purchased at an office supply store. It is a very mediocre paper in my opinion, but will do the job for this test build.
Again, my expectations are low regarding the final model ( especially since this is a very simple rendered part with mo details at all ). This is only a test build.
Here is a picture of the part which was scanned. notice that the scanner picked up the wrinkles, however, it is printed on a flat sheet, so it only looks that way.
printed parts are flat:
Glue tabs:
The normal old way of glue tabs is always flat strips
however, I need it notched so the parts can fit over the glue strips.
Here is the forward fuselage sections
mid section
aft sections
Isaac