Thread
:
Hubble Build
View Single Post
09-28-2019, 05:06 PM
sreinmann
Member
Join Date: Jan 2015
Location: Columbia, MD
Posts: 549
Total Downloaded: 313.46 MB
Finally completed after two years, with a substantial hiatus in the middle while I figured out a better method of handling the grab rails. Eventually, I settled on some craft card stock that was colored through and through. I bent down the last mm of each end to connect to Hubble or stacked a mm of paper in a square to stand it off the body. I also kept the PVA and hGA antennas unglued, slipping into a sleeve on the bus to support it in place. That will make transport much easier in the future.
Attached Thumbnails
__________________
Happy Crafting - Scot
On the Bench: Planck and Hershcel
sreinmann
View Public Profile
Send a private message to sreinmann
Find all posts by sreinmann