Here are the forward parts
mid section
aft parts
Note:
This construction calls for the fuselage sections to be glued and joined on the frames. In the past, I found that trying to mate all the joints will be hard. So this method is no good for me. Also, as I stated before, this is such a simple round section fuselage, that it does not need all the elaborate framing.
so.....
I will cut off all the protruding frames like the vertical tail and air inlets.
I will then build the fuselage sections and join without any frames.
I will sand the forward sections to allow me to slip the entire rear framing into the fuselage skins.
Back to the build:
remove the vertical protruding frames
-->
remove the air inlet/wing stubs frames
--->
more next
Isaac