Hello everybody,
and today the new
GH2 Press. Line made of
Nickel silver wire (Ø 0,4 mm), which is bent even more precisely, whereby it can easier cling to the
Cable Tray and around the
LH2 Feedline.
Bending the wire was a bit more difficult, as the Nickel silver wire is less ductile than the Copper wire, but after a few tries it went smoothly.
And also with the
Fittings from
insulating hose the line fits well.
When inserting, I always put the long end first in the opening in the
Umbilical plate,
and then the front end into the in die
TPS cladding of the Press. Line.
This allows me to paint the line separately and then finally insert it.
After that the
LH2 Umbilical is done, I can go on with the
LO2 Umbilical on the other side, where again the
Cable Tray with the
Supports has its turn.