Hello everybody,
well, this slanted front part of the
Cable Tray(Part 3.4) really has it in it and has almost already become to a nightmare of my sleepless nights ...
But meanwhile I'm of the opinion that one edge more or less doesn't matter, and therefore I will be content with an approximate solution, especially since later one cannot see this part under the orbiter from the outside anyway.
The biggest difficulty in interpreting the course of the contours in the front area was this red circled notch directly under the
Center support, which I have yet still decided to do,
Source: NASA
which can be clearly seen again on this image section.
Source: forum.nasaspaceflight.com (DaveS)
And in this image one can also see the front area relatively well, where I will then orient myself during scratching,
Source: NASA
especially since this is only a short stub of about 5 mm length anyway, as one can see here.
For the upper closeout, I've glued a
Strip (0,25 mm x 1,5 mm x 3 mm),
and the lateral closeout will follow next in a similar way, wherewith I will then content myself.
