Thread: FW 190D-9, 1:33, Halinski 3/2011
View Single Post
 
Old 11-26-2019, 01:53 PM
Dayn's Avatar
Dayn Dayn is offline
Member
  
Join Date: Oct 2009
Location: Switzerland
Posts: 144
Total Downloaded: 61.41 MB
FW 190D-9, 1:33, Halinski 3/2011
.. following works on the tube of the machine gun.
1. I Drew a template. 2. I used a tin wire. 3. Holes are marked with a center punch. 4-5. An aluminum ribbon makes it possible to form the rings. 6-7. Final result
Attached Thumbnails
FW 190D-9, 1:33, Halinski 3/2011-92d80547-9369-4924-b40e-d1a6e984ab30.jpg   FW 190D-9, 1:33, Halinski 3/2011-69a1e676-7f43-4f58-9941-85725b52320f.jpg   FW 190D-9, 1:33, Halinski 3/2011-5214e6f2-b7f2-4130-a2aa-6e46851de095.jpg   FW 190D-9, 1:33, Halinski 3/2011-1a389038-8153-4163-8b4c-e142ee176c5d.jpg   FW 190D-9, 1:33, Halinski 3/2011-316fdf79-ef3d-41ae-9e7f-6e04dc8b7438.jpg  

FW 190D-9, 1:33, Halinski 3/2011-635d9891-0bad-47bc-9e7e-198819f1d4b4.jpg   FW 190D-9, 1:33, Halinski 3/2011-cb4faa57-177f-43d6-84f5-f6aa3af3002e.jpg  
Reply With Quote