Thanks for the tip JohnGay. I have had a little experiment and found (at least for me) that you do need to be very accurate with the spacing and cutting of the "alternating" tabs. However the end result was good. As I do everything by hand (though I wish I knew how to use Pepakura and other software) I found this is doable for straight line joins (in the same plane). However for curved line joins even in the plane, let alone twisting in 3d space I just found it too hard to do unfortunately, which is a pity.
Regards
Kevin
__________________
Normally the most advanced tech I use is a pencil.
|