I’m in the middle of construction now. I first reduced it to roughly 60% to fit on letter paper. Once printed however, it was too small with lots of very small parts. I ended up printing on multiple pages using the snapshot function in Acrobat Viewer. I still had several pieces that needed to be spliced back together and lots of duplicate parts but it works 👍
I found a few places where the texture didn’t line up with the tabs that I fixed when edge coloring. Also the fold lines are difficult to see due to the texture. There are a few things that I would have done differently in the unfold and layout department but I’m very happy to have this kit
Mine is coming together slowly. Looks to be about 14 inches long and 10 inches wide when completed. I will post some photos later.
If you have questions I will do my best to help out🙂
|