|
Hi Rick, many thanks for your offer, yes please if you can upload the drawings that would avoid any potential further raising of my blood pressure!
I've just sent the drawings to you via gmail, completely unsure whether I have the correct address but it hasn't bounced back yet; tried a pm but no way that I could see of attaching them to that.
If and when they appear in the downloads section, please note the blurb on the sheet containing the formers about paper thicknesses which are all based on the use of cereal box cardboard for formers and 160 gsm card for other components. These work for 1:100 scale but if enlarging (I've included a scale rule) you would find a very sloppy fit and so would need to adjust as appropriate to avoid excess clearances.
As to reducing to 1:200, fit should be fine but I have to say that the struts were fragile enough for me at 1:100; I would suggest wire or, more expensively, brass etched components instead at this scale.
Very much hope that the drawings are found useful.
Best wishes to all
Chris
|