glue the upper center fuselage skin to the forward section
belly skin will be added after mating the wings on.
insert and glue the center section framing
Note : this will end up being no good !
ready to join the aft section
Note 2: because the joint going aft is relatively week, I added a wood dowel to the framing to add structural support.
join the aft section
I had to use low tack tape to keep it all together. A- the glue just was not sufficient. B- the aft section was a bit warped and would not conform at the joint line.
when removing the tape, it just pulled off the colors ( a stupid move on my part ).
Isaac