View Single Post
 
Old 10-03-2009, 07:02 AM
silveroxide's Avatar
silveroxide silveroxide is offline
Eternal Member
 
Join Date: Jun 2009
Location: Fayetteville, NC
Posts: 2,563
Total Downloaded: 23.70 MB
manned walker

Presently I am at the legs section but here are some more updates in sequence.

On the side sponsons, I made a complete boxed in set, by giving it a backside. I used a heavy card template inside the outer walls for strength, instead of that little box shape thing. I also cut out the small vent holes.

Glued the access panel in the open position to display the engine. Made the swing out bracket rod which also helps to stabilize the panel in the open position.

In the rear exhaust engine panel, I boxed it up and then I cut out the circle where the engine and fuel rods will go. The reason will be more apparent when I get to those parts. It will make it more steady and strong.
Attached Thumbnails
Manned Walker Mech-026.jpg   Manned Walker Mech-027.jpg   Manned Walker Mech-028.jpg   Manned Walker Mech-029.jpg   Manned Walker Mech-030.jpg  

Manned Walker Mech-031.jpg   Manned Walker Mech-032.jpg   Manned Walker Mech-033.jpg   Manned Walker Mech-034.jpg   Manned Walker Mech-035.jpg  

Manned Walker Mech-036.jpg   Manned Walker Mech-037.jpg  
Reply With Quote