U.S.S. Voyager NCC-74656/ 1:800 - Page 2

**Christine U** · #11 09-26-2010, 10:05 AM

Not much left to do: connecting the inner shuttlebay part to the inside of the bay door, turning the whole thing around, taking a picture and: voila! the next section is done... so far...

**Millenniumfalsehood** · #12 09-28-2010, 04:00 AM

Phenominal build so far!

Can't find a place for it? I think I could clear some shelf space over here.

**Christine U** · #13 09-29-2010, 12:35 PM

Dont´t you worry, guys - I will find a place, that´s for sure! The "problem" is, that all the really good places already are occupied with something (not only papermodels) - so I will need to find other places for the other stuff... and so on...

But - "don´t sell the bears skin before it´s shot", or something like that? Actually I am fighting, ah, building the wings...

**Millenniumfalsehood** · #14 10-03-2010, 12:53 AM

Is hanging it on the ceiling out of the question? Seems like a lot of unused real estate that could go to hanging Voyager when she's finished. Maybe put the ship in one of the corners of the room.

**Christine U** · #15 10-18-2010, 03:56 AM

@Millenniumfalsehood> it have to hang it some place anyway - all other possibilities er covered with books...

Okay. let´s start:
This part took it´s time...
Before to start building the stern together, I attached the windows and the extra parts. The big picture shows the parts to be attached next.

**Christine U** · #16 10-18-2010, 03:58 AM

After a while I found an answer to the question how to build it...
Befor I attached the mid-part, I fixed the part which later is ment to support the warp nacelles. It´s easier to attach before you need to take care of the rounded wing mechanism.

**Christine U** · #17 10-18-2010, 04:02 AM

Suddenly I noticed that there is no flap on this little corners on both wings (marked green)... but there is enough flap left from glueing the wing mechanism which can be used.
After closing the wings I attached the back and front side, and now it´s time for the down side of the stern.

**Christine U** · #18 10-18-2010, 04:05 AM

From now on it´s time to be careful with the rounded wing mechanism...

**Christine U** · #19 10-18-2010, 04:08 AM

Already when I build the 1:1700 version of the Voyager, the "impulse engines" where no easy part to attach. In any case it didn´t went out worse than expected...

**Christine U** · #20 10-18-2010, 04:10 AM

Before attaching the "impulse engines" and the phasers I found out that a support is needed to stabilize the space between the upper and down side of the stern.
Fortunately I had the right thing at hand... (okay, it could be 0,1 mm thicker, but I don´t think this is something which will be noticed at all).
After the stern is done I will continue with the warp nacelles (and I am nearly sure it will be horrible and complicated...).