Looking for Star Wars Rebel Blockade Runner - Page 2

**legion** · #11 08-21-2011, 01:37 PM

Interestingly, the Star Destroyer that chases it around Tatooine was the same size as the Tantive IV...

(Another odd fact is the storm trooper bodies used in the upper superstructure of the Super Star Destroyer)

Neptune · #12 08-21-2011, 05:16 PM

I found a nice little mesh I can make a card model from.

**OhioMike** · #13 08-22-2011, 10:59 AM

I was hopeing we were talking about the blockade runner from the 1st movie. The one that escapes from the ice planet Hoth?

**atomgas** · #14 08-22-2011, 11:31 AM

Rebel transport, Ice planet Hoth = 2nd movie.

**gomidefilho** · #15 08-22-2011, 01:08 PM

Hello my CR-90 is a simple model designed by Enterprise E, is a meshe from Star Wars Homeworld mod, you found in paperstarships site...

**Sandro1955** · #16 12-19-2014, 02:27 AM

I try to made this Pepakura Blockade Runner Paper Model... is hard... you must make many "modification" on project but the result is very good... the best Blockade Runner Paper Model on the Web....

**Millenniumfalsehood** · #17 01-02-2015, 07:13 PM

If you want to model the Night Caller, you're not going to want to use the CR-90. It's not even close to the right size, being far too small. I know, I know, the ship in the novel is described as a CR-90, but it's still too small. The hammerhead of a CR-90 would barely fit one X-wing, and that's by gutting it out. For it to fit most of Wraith Squadron, it would have to be MANY times larger than it is.

**ARMORMAN** · #18 01-02-2015, 09:08 PM

Sandro,

Post some pictures of your build.