Rifle from "Oblivion" 1:1

**tekzo** · #1 03-02-2013, 12:15 PM

never been built a 1:1 weapon before, after watched the thriller there's a lot good stuff to make the model, start with the aircraft (soon I will make the thread ) and the rifle. It's gonna be about 80-90 cm, plan add with inner flap and box frame.
regards,

**KCinKC46** · #2 03-02-2013, 07:06 PM

There is always room for another Sci-Fi gun. Will be following this one.

**tekzo** · #3 03-03-2013, 04:28 AM

Quote:

Originally Posted by KCinKC46

There is always room for another Sci-Fi gun. Will be following this one.

thanks KCinKC46, need to adapt with huge model (more than 30cm) got to re-plan while under testbuild phase
regards,

**KCinKC46** · #4 03-03-2013, 12:00 PM

The testbuild is looking good. Are you thinking of putting some kind of skeleton inside to support it? Kind of like what was done with the big Sulaco model?

**tekzo** · #5 03-10-2013, 08:07 AM

Quote:

Originally Posted by KCinKC46

The testbuild is looking good. Are you thinking of putting some kind of skeleton inside to support it? Kind of like what was done with the big Sulaco model?

yes my friend, I use long box as inner frame front and backside, well after a testbuild and complete the pattern, here's the final one.Hope you all like it.For free download here
best regards

**Vermin_King** · #6 03-10-2013, 06:55 PM

Oh, this deserves a place on my wall. Thanks. And thanks for all your models.

**tekzo** · #7 03-12-2013, 04:52 AM

Quote:

Originally Posted by Vermin_King

Oh, this deserves a place on my wall. Thanks. And thanks for all your models.

thanks for the word my friend, well hope I can make some weapon in my next project

regards

**Rhaven Blaack** · #8 03-15-2013, 07:30 AM

this looks really good. My only concern is that the entire lower receiver set-up (i.e. the handle, trigger and guard, and magazine well) are too big and out of proportion to the rest of the weapon.
I was comparing the one that is in the photo with Tom Cruise, to the one that you have.