Stealth Talon WIP - Page 5

**ARMORMAN** · #41 12-28-2011, 11:13 PM

Finally, another page of instructions is done....(if only I had not set such high standards for myself....oh well...)

**kjev** · #42 12-31-2011, 07:50 AM

Man, never be afraid to have high standards!

**ARMORMAN** · #43 01-03-2012, 11:03 PM

OK, Had to change the instructions a bit. I have a question:

Does the final pic on step 10 read clearly as to what I'm trying to get across?

Quiz question:

What am I telling you?

**Rhaven Blaack** · #44 01-04-2012, 02:16 AM

Everything looks good to me. I would have no problems following your instructions.

**kjev** · #45 01-04-2012, 04:43 AM

I think so.

**Paragon** · #46 01-07-2012, 05:27 PM

So it means from the side view, texture should be visible for the front part, but not the back "bucket"?

**ARMORMAN** · #47 01-07-2012, 06:10 PM

Um....no. I don't want to answer it yet, I do really want you're (as in all of you's guys) input.

**jaffro** · #48 01-07-2012, 11:29 PM

ummm... you skin the little grey box thingy, then you insert it between the two side bit thingies, then you need to make sure the bottom of the whole assembly sits level/flush or something?

**ARMORMAN** · #49 01-08-2012, 12:21 AM

We have a winner! Yes, the the seat base and the two side panels must be flush to fit right. Thanks for playing "What is the Designer Trying to Say?"

With your host, Biiiiilllllll Perrry!

**modelnutz7** · #50 01-08-2012, 08:01 AM

Hi Bill, Your instructions are ACE no problems here understanding them.
Can't wait till this fantastic model is available.

Best Wishes

Tom
Scotland UK