YT-1300 Freighter - Page 3

**legion** · #21 08-08-2009, 05:59 AM

Makes more sense to me to have it point outward, for more visibility. Though i think i can fix it if i push hard enough.

**imcold** · #22 08-08-2009, 09:37 AM

I'd rather not do that, it could (most probably would) damage the paper; not worth the risk imho. It will just block the cannon's way slightly I think, that's what I was afraid of.

**legion** · #23 08-08-2009, 04:58 PM

Imcold, you got any pictures of the topside gangways? Like where F-19/F-20 goes?

**imcold** · #24 08-09-2009, 01:25 AM

The top is almost a copy of the bottom. I didn't take much wip pictures, here's the link for the gallery, hopefully it'll be helpful: YT-1300 korveta pictures by imcoldz - Photobucket
Note: mine is downsized to two thirds.

**legion** · #25 08-09-2009, 03:00 AM

Those will help a lot, thanks! But there's a slight delay... I messed up the placements of some of the support pieces for the upper hull. Have to print those pages all out again...

**RodentMaster** · #26 08-09-2009, 11:26 PM

Now all we need is somebody to come up with 5 landing legs, and a ramp/interior (only need to do the maing tunnel branch left/right, don't see much past that!)

**legion** · #27 08-16-2009, 08:31 AM

Right, she be completed. Not perfect quality, but good enough for me. Main errors: bad skin alignment, which causes the cockpit area to be off as well. I messed upon the side docking hatches... didn't see they were set inside, so i glued them on top...

Here's a link to the gallery (bit of a mess, the script i use for it isn't too advanced).