|
|
|
#41
01-08-2018, 10:23 AM
|
||||
|
||||
|
Hello !
The next parts - north portal and stair tower. Portal and door is offset ... and glued to the aisle. With the buttresses and tops, the north portal is completed. I will grow the stair tower later. Best regards Kurt 
|
|
#42
01-09-2018, 11:59 AM
|
||||
|
||||
|
Hello everybody ,
With the roof rider, things are starting to get a bit higher. The beams of the roof rider are cut out and individually glued at an angle. Let the lantern and tip dry well ... and assemble the whole thing on the roof. A gothic jewel slowly grows into the sky. Best regards Kurt
|
|
#44
01-10-2018, 12:17 PM
|
||||
|
||||
|
Tha nk you Russel ,
let´s go on ... Hello everybody Part 36 has a lot to refine. I put the portal inside three times ... ... and the Gothic ornaments with 1.5 mm raised to the outside. With a height of 18 cm is the lower tower, a rather large part ... ... and fits very well to the central nave. Best regards Kurt
|
|
#46
01-13-2018, 07:36 AM
|
||||
|
||||
|
Thank you MrCronk !
Hello Of the big buttresses, there are six pieces, the figure niches I put back. After installing the first pillar ... ... now the previously completed stair tower can now be added. Between the two large pillars a smaller one is grown - a truly fascinating model! Best regards Kurt
|
|
#47
01-14-2018, 01:57 AM
|
||||
|
||||
|
Hello !
Separate and reinforce the parts for the west portal ....... Now glue the portal without straps ... .. to the pillar. With the pillar 42, the west portal is complete. Best regards Kurt
|
|
#48
01-16-2018, 12:26 PM
|
||||
|
||||
|
Hello !
The retaining wall 47 should be mounted in front of the pillar 43 ... so I achieve a great fit. For the buttresses 45 + 46, the length must be shortened by 3 mm by placing the lower tabs upwards. Thus, the roof pillars fit well. The retaining wall 48 lacks almost 2 mm ... ... which I simply replace with Finn cardboard. Best regards Kurt
|
|
#49
01-17-2018, 02:23 PM
|
||||
|
||||
|
Hello !
From the parts 48 to 48 f the tower chapel is built, whereby there are some things to refine. First, part 48 is prepared ... ... where a line should arise inside, whereupon later the roof rests. The glued together chapel ... ... now grow on the tower. regards Kurt to the top
|
|
#50
01-18-2018, 12:46 PM
|
||||
|
||||
|
Hello !
On the edge of the reinforcement, the frame is now glued on without straps. In the small buttresses, I glue a strip of 3 mm Finn cardboard. The roof is reinforced inside with 0.9 mm ... ... and glued together. Now mount the pitched roofs 48 c on the fixed roof. The tower chapel is now finished with the portal. Best regards Kurt
|
| Google Adsense |
 |
|
|
Linear Mode
