Sea lighthouse in Kolberg Poland - GPM - 1:150

**Styrian Spitfire** · #1 06-06-2020, 11:56 PM

Hello friends of maritime architecture

In between I will build a model again that will be finished soon.
I chose the Baltic Sea lighthouse in Kolberg, Poland. With 31 parts, the construction is quite clear.

Except for the reinforcements, I will build the lighthouse as it is intended in the arch construction.

Sincerely yours
Kurt

**Kevin WS** · #2 06-07-2020, 12:29 AM

Look forward to seeing it.

**Styrian Spitfire** · #3 06-10-2020, 11:41 PM

Hi Kevin ,

welcome on board

Reinforce the base plate with 1.5 mm Finn cardboard ... I cut the original tab and replace it with one
behind the glued tab, reinforcement prepared ...

... join together after coloring the edges ... but do not stick to the base plate yet

Sincerely yours
Kurt

**Styrian Spitfire** · #4 06-17-2020, 11:24 PM

In part 3 the serrated flaps are not used, instead 1.5 mm Finn cardboard is used for reinforcement ...

now cut off the ring ...

... insert from below ... fits perfectly, even without glue

Now divide the reinforcement into individual strips and glue in ... glue with the base plate

Sincerely
Kurt

**Styrian Spitfire** · #5 06-17-2020, 11:26 PM

now the pictures

**eatcrow2** · #6 06-18-2020, 06:02 AM

Excellent photos showing the process!

**Kevin WS** · #7 06-18-2020, 07:15 AM

I like the model graphics very much.

It is going to look really good SS!

**Styrian Spitfire** · #8 07-04-2020, 03:36 AM

Thanks to eatcrow2 and Kevin

Also cut off the flaps on part 8 and glue the frames ... then close with part 11 at the top

Cover the railing inside with gray cardboard ... and stick it on

Best regards

Kurt

**Styrian Spitfire** · #9 07-11-2020, 12:08 AM

Part 12 is doubled and cut up with gray construction paper ... stick the whole thing on top

Part 10 a ... glue all around

Sincerely
Kurt

**Kevin WS** · #10 07-11-2020, 12:58 AM

Looking good Kurt!