does anyone know how to make a stencil

[mchale]

I need a stencil made for painting flames on a model car and not shure how to make it I can't seem to get it right in ms paint that's on my laptop and I can't get Internet on it without a card don't have a card so I can't Download any programs to it if any one can help please I will post pics in a few minutes I cant post pic from my iPad

[spaceagent-9]

someone here will post the flames you need to cut and paste into paint
for what you need. if you describe what you want i think i can

[mchale]

here is the pic and my rough draft drawing and my attempt at using paint

[mchale]

does anyone know how to turn that angle pic in to a side view with some tool on ms paint

[blaar]

mchale, MS Paint is very limited and I really recommend you try using something else.

Paint.Net is free, small and very easy to use. There is also loads of plug ins and other tools you can use with it. Give it a try.

www.paint.net (http://www.paint.net/)

NS : Keep in mind if you download Paint.net you will need .NET framework too.

[spaceagent-9]

you can try skew in image mchale,.....you might hae to fool around a bit to find out what you like in the after image

[Inky]

Usually for flames I either just free hand draw them onto the model or I will draw them on cardstock then cut them out and trace the pattern. You can google, "flame stencils" and get allot of good pictures of flames to look at to get ideas.

[ProjectKITT]

What is that? A '66 GTO?

I did a quick Photoshop assuming it's something similar. If that's what you're looking for mchale, I think I can make a line drawing that prints correctly from MS Paint.

[mchale]

That is what I was looking for projectkitt

[ProjectKITT]

Cool beans. I forgot to ask, do you want the "MM" graphic on there, or just the flames?

[mchale]

Just the flames I have my own mm graphic

[ProjectKITT]

Okay I've got just the flames drawn. Can you measure your model to about where the red lines are on the picture I attached? Then I will know how to scale it.

Or if you know the scale of the model car you are building I can put a few sizes on a sheet; one of them should be close.

[mchale]

It is 1/24th scale

[ProjectKITT]

Hopefully one of these will work. When I converted from BMP to PNG to post on here it changed the resolution a little but not much. The entire image should fit on one page, if not just set the margins in Paint a little smaller. You can also try page scaling if you want them a little larger.

[mchale]

Awesome job thank you

[ProjectKITT]

Glad I could help :)