View Full Version : Canon Pegasus
Sidewinder81777
09-12-2009, 09:30 PM
This is a slight change from the models I normally build. Its the pegasus from the Canon Creative Park site. Made it for my girlfriend just thought Id share it.
Ron0909
09-12-2009, 10:04 PM
Oh that's 10 points on any relationship scale! Really nice pegasus supurbly done
Ron
bill516
09-16-2009, 03:08 PM
I did one too but at half size and on 100gr paper, it made for an interesting time doing the hoofs. Shame about the join for the wings on the body, at least its on the back and you dont really see it. I also had to add some weight in the tail as it kept tipping over
25079
25080
25081
25082
Bill
dansls1
09-16-2009, 07:23 PM
Nice models ;)
ct ertz
09-17-2009, 04:43 AM
I have this one downloaded along with a few other critters from Cannon. A lot of parts with all those curves. Was it hard as paper models go? They came out nice,
CT
bill516
09-17-2009, 05:41 AM
Not as hard as some models I have done but htere were a couple of tricky bits. The mouth part was a tad hard but that was more to the size I was workin at as were the hoofs. Another bit that gave me a problem, and I suppose its common to all models, was joining the two hal.ves of the body together, its the how do you press the last join inside a box together syndrome
Bill
Wyvern
09-24-2009, 10:54 AM
Those look really good, Sidewinder and Bill!
I hope you scored some points doing that for your GF, Sidewinder.
Wyvern
cjwalas
09-24-2009, 12:43 PM
These both look fine, indeed!! I've had my eye on this one for a while as I'm looking for non-airplane flying things to build and hang from the ceiling. This one looks like a candidate for sure! Thanks for sharing your efforts.
Chris
vBulletin® v3.8.8, Copyright ©2000-2024, vBulletin Solutions, Inc.