|
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
Quote:
Regards, Charlie |
#12
|
||||
|
||||
Quote:
Curt |
#13
|
||||
|
||||
I managed to finish the gun cradle over the last few days. The attached photo shows the gun barrel dry fitted to the cradle in the deployed configuration.
In this configuration some of the interior parts are completely hidden which takes some of the pressure off of getting them totally correct. While handling the gun barrel I managed to to detach the breach assembly from it. Then I noticed that part #7a has a center hole 3 mm in diameter that was supposed to be cut out. I think that the mandrel for the gun barrel is suppose to fit into that hole, or at least it would be a good idea for the mandrel to protrude about 2 or 3 mm from the butt end of the gun barrel so that it would fit into this hole both centering and securing this part. For now I simply re-glued the breach a bit more securely. Next I think I'll take a look at the wheels and the axle assembly. Curt |
|
|