#11
|
||||
|
||||
Quote:
I've got the 1996 SdKfz 7 model as well - same glossy paper. That will be even harder to print on decent card because there are lots of parts which are nearly the full length of a B4 page. I don't have a solution for that one yet. There are still some bits to finish on my Flak model but it's hard to get motivated. I've been quite impressed by GPM's artillery models - they look quite challenging but quite doable. Regards, Charlie |
#12
|
|||
|
|||
Quote:
if you have printed the model on smaller size paper - wasn't it de-scaled? SDKFZ 7 is difficult model, built 7/1 and found many errors with design (there are 3 models from Hal's sharing the same parts - 7, 7/1 and 7/2) so dont expect easy job, even excluding fabulous glossy paper cheers |
#13
|
||||
|
||||
Quote:
The solution for the SdKfz 7 seems to be to scan the B4 pages then reorganise the parts onto a custom size 210mm x 420mm (this is A3 cut down to A4 width). This will go through an A4 printer once you set a custom paper size. Regards, Charlie |
Thread Tools | |
Display Modes | |
|
|