#21
|
||||
|
||||
and further ..
A little differentiated ... are the middle suspensions Two filigree shock absorbers Parts 165 to 168 provided with two rivets ... and glued to the rear Yours sincerely Kurt |
#22
|
|||
|
|||
It Look Stunning !!
|
#23
|
||||
|
||||
Dear Kurt! As always your builds, so clean and precise, are absolutely amazing.
Another little jewel is growing under your hands. After all that bolt work you can also consider painting the whole model after completion. The final result should be comparable (if not superior) to any plastic model. Great work! |
#24
|
||||
|
||||
Ciao Tonino ,
thank you for the nice comments , a happy new year to Italy letīs go on Now the planetary gears, for the visible side, the openings are cut out and pasted with 0.1 mm gray paper behind, in between 1.5 mm Finn cardboard ... between the wheels glue the spacers, and provided the wheel with rivets. Kind regards kurt |
#25
|
||||
|
||||
Great work Kurt!
__________________
The SD40 is 55 now! |
Google Adsense |
#26
|
||||
|
||||
Thank you Kevin ,
now letīs go on A hodgepodge of hangers and wheels ... are placed Now 46 wheels parts plus 140 rivets ... the hand-cut running surfaces are glued and dyed with paper strips Two wheels each are connected by spacers (0.9 mm) Yours sincerely Kurt |
#27
|
||||
|
||||
Hmmm - rather you then me at this stage!
__________________
The SD40 is 55 now! |
#28
|
||||
|
||||
The next series production - four times suspension for the wheels ... a 1.2 mm steel wire is a glued ... ... after good drying on the suspension glue. Yours sincerely Kurt |
#29
|
||||
|
||||
Excellent suspension. What a lot of detail. Great job.
__________________
Regards, Don I don't always build models, but when I do... I prefer paper. Keep your scissors sharp, my friends. |
#30
|
||||
|
||||
Wonderful finish, best appreciated with low-angle lighting.
Perhaps you already talked about this, excuse me if I didn't notice: what is your rivet making technique? It's very effective. |
Google Adsense |
|
|