#71
|
||||
|
||||
That's really looking good...
__________________
Replicating Excellence-> https://ecardmodels.com/vendors/replicating-excellence |
#72
|
||||
|
||||
Good work Igor
__________________
David........... Paper modelling gives you a happy high. currently building. c GAZ 51 ALG 17, wagon 111a. unex DH411 excavator and spitfire Mk 9 |
#73
|
|||
|
|||
Just your paper engine is already epic
|
#74
|
||||
|
||||
What you are achieving in that engine is wonderful Igor.
|
#77
|
||||
|
||||
I proceeded to the assembly of distribution pipe.
Once again I realized how I do not like pipes and especially bending ones, with addition of paper, which strives to exfoliate at the earliest opportunity. Extension tubes are not glued, because i don't know if the length will be enough for connection to filters tubes. I didn't glued the pipe yet, since it was assembled only to help fit carburetors. Although the black paint has already arrived, I was doubly glad, as I found black wire with a suitable diameter for pipes from the carburetor to the blocks and another one for pipes from the radiator to the blocks. So less mess with the paint In addition, this wire is stronger than solder one. On the left side, a bar with carburetors is attached to the edge of the block and adjusting the pipes was easy. On the left side I sweated a little, because the bar is kept in the air on two pipes, and it was necessary to measure a lot and adjust it, so that everything would sit on one level. As expected - distribution pipe and throttle stem helped to achieve it.
__________________
Welcome to my gallery |
#78
|
||||
|
||||
Stunning work.
__________________
"It's all in the reflexes." |
#79
|
||||
|
||||
Thanks gotham
Continued to equip the engine Assembled oil filter When gluing the sphere of the filter case, I used the method with holes. I put a little smaller hole on the cylinder and fix it with glue. Then I put on one smaller and fix it and so on until the sphere is closed. In this way, the tabs bend and connect evenly. And the filter is ready Maintenance step and crankcase dry breather Set everything in place Next step is the radiator!
__________________
Welcome to my gallery |
#80
|
||||
|
||||
Will the engine be removable from the hull ? It's just that it would look great on display beside the completed tank.
__________________
"It's all in the reflexes." |
Google Adsense |
|
|