#1401
|
||||
|
||||
Very fine Laura is a hard kit to make because a facetas build fuselage! Well done!
|
#1402
|
||||
|
||||
Thank you my friends for your well wishes and compliments.
|
#1403
|
||||
|
||||
Thanks, Pericles, the fuselage is not as hard as the engine which is shaped like a fruit. Eh, the upper part of a star fruit but with round ridges instead of pointed one, and after finishing, I had to cut away some specific part of the sides of the engine for the whole main wing to pass through until it stops at the middle as marked. That I think is the hardest part because two of the side round ridges are smaller than the top one but it's done at the end without too much trouble.
|
#1404
|
||||
|
||||
No.125 Mitsubishi F1M Pete, OBP model, originally 1/32
No.125 Mitsubishi F1M Pete is now here to join us. The scale is originally 1/32 and this is an OBP model. The current Pete by Murph Model has a green main float, unlike this one. The props are able to turn by finger. I have added a pilot's seat to the cockpit to fill the front hole of the fuselage as it would have been empty and looks awful.
|
#1405
|
||||
|
||||
Again very fine work my friend! I build the same plane in 1/100 scale...
|
#1406
|
||||
|
||||
Thanks. I have seen your work on Murph's webstore, showing a green main float.
Very good looking Pete that you built. |
#1407
|
||||
|
||||
Amazing small scale work again papermate!
__________________
''Oh, stop whining! Can't you just print off another one?''- my wife ca 2018 |
#1408
|
||||
|
||||
Wonderful papermate work, the precision you get in these little jewels is incredible.
|
#1409
|
||||
|
||||
Thank you, Rata and Sergio, for your encouragement.
|
#1410
|
||||
|
||||
Its seems that there is a tsunami on your models, may be aichi or kawanishi multiengine is coming!
|
|
|