Mirage 3c

[paperengineer]

Great job. It's already taking shape!

[na120372]

I continue to build the Mirage 3C.

Pitot tubes are made carved a toothpick.

My Mirage is like going to complete construction only when a canopy and a few parts.

[YOAVHOZMI]

very good Kim my friend.....i like your work.

what happend under the wings, parts no' 30C+31C ? the printer run out of ink?

regards

YOAV

[na120372]

Originally Posted by YOAVHOZMI

very good Kim my friend.....i like your work.

what happend under the wings, parts no' 30C+31C ? the printer run out of ink?

regards

YOAV

HI YOAV

30C and 31C part of a color other reason is because almost no printer ink when printing.

I replace the printer ink to print again after making'll modify the 30C and 31C part.

Your friends

KW KIM

[tatasam]

Hi, Nice work na120372
I build the same model and I have no trouble with elements 30c, 31c
Regards , Henryk

[Ofanim]

Nice Mirage !
I know that feel when you're running out of ink
I have printed thisMirage too and the lack of black ink is visible on the triangles but thankfully it only gives a weathered look.
Regards,
Ronan.

[Isaac]

The best way to print any model is to make sure you have :

a clean printer head ( clean before you are ready to print ) ,
check alignment,
make sure you have at least half ink in each ,
and that you have enough card paper of the best quality in the printer.

Anything less is asking for variations at a minimum or a bad print of all pages.

Also, I print all the pages at once. If you print some later, they will not be the same colors.


Isaac

[YOAVHOZMI]

i always has HP printers

now i have HP printer model 2515 and it Enough for best printing quality for 2 big models, or 3 models scale 1:50.

after printing 2 models with best quality, i replace the inks with new ink cartridges.

also, like Isaac said, i print all the pages at ones, and some pages with difficult parts i print twice....for spare.

with this method i avoidable from stucking with situation that there is not enough ink in the printer and prevent different colors at my models.

YOAV

[na120372]

I want to thank all my friends who me some advice.

I had to modify the construction and re-print section 30C and 31C.

[na120372]

Originally Posted by paperengineer

Looking great! Are you going to make his kfir once you finish this?

The Mirage is incomplete. But I also began to build KFIR.