#11
|
||||
|
||||
Quote:
Look at these photos of the wings tops. The lighter color is blueish on the right and center and gray on the left But I think it must be my printer that is screwing up. The only variable is that all the wings are printed on the same sheet. No worries. Isaac
__________________
My gallery [http://www.papermodelers.com/gallery...v-r-6&cat=500] Recent buildsMeteor F1, Meteor F8, Mig-Ye8, NA Sabre, A-4E Skyhawk,Mig-15 red, Mig-17 repaint |
#12
|
||||
|
||||
Oh.. i see it now in the first picture. It does seem off-color.
I share your suspicion. It could be a printer ink issue. On the diagram, the first wing is on the top portion of the paper while the second wing is under it. |
#13
|
||||
|
||||
Pilot side fuselage
Here is one side. I decided to build it as is with the landing gear bays. My original intent was no interiors, but it is too difficult with this model.
So here it is partially Isaac
__________________
My gallery [http://www.papermodelers.com/gallery...v-r-6&cat=500] Recent buildsMeteor F1, Meteor F8, Mig-Ye8, NA Sabre, A-4E Skyhawk,Mig-15 red, Mig-17 repaint |
#14
|
||||
|
||||
Fuselage continued
The landing gear bays here
Will be inserted and then the whole thing fitted to the wing. That will be later when I finish the other fuselage. Isaac
__________________
My gallery [http://www.papermodelers.com/gallery...v-r-6&cat=500] Recent buildsMeteor F1, Meteor F8, Mig-Ye8, NA Sabre, A-4E Skyhawk,Mig-15 red, Mig-17 repaint |
#15
|
||||
|
||||
Attached one fuselage
I decided to attached the left fuselage.
First glue the landing gear bay and then dry fit to the wing and engine side. Next is the other fuselage and then add the canopy. Isaac
__________________
My gallery [http://www.papermodelers.com/gallery...v-r-6&cat=500] Recent buildsMeteor F1, Meteor F8, Mig-Ye8, NA Sabre, A-4E Skyhawk,Mig-15 red, Mig-17 repaint |
Google Adsense |
#16
|
||||
|
||||
Eric
Color issue appears to be a one off event. I am home again and reprinted the same page on the same printer and everything is fine with the wing color. Not sure what happened , but at this point, the built model will continue as is. So the file is correct. If I decide to built this model again, I would upscale it to 1/33 and have a clear canopy and a cockpit. Thanks Isaac
__________________
My gallery [http://www.papermodelers.com/gallery...v-r-6&cat=500] Recent buildsMeteor F1, Meteor F8, Mig-Ye8, NA Sabre, A-4E Skyhawk,Mig-15 red, Mig-17 repaint |
#17
|
||||
|
||||
Hi Isaac,
Great to see how the model is coming along. I hope the wheel wells didn't give you a lot of headaches. Eric |
#18
|
||||
|
||||
Quote:
Actually the wells were OK. My preference at such a small scale was not to build them, but it was easier not to change things. I am home this week, so no building of the models for now. Isaac
__________________
My gallery [http://www.papermodelers.com/gallery...v-r-6&cat=500] Recent buildsMeteor F1, Meteor F8, Mig-Ye8, NA Sabre, A-4E Skyhawk,Mig-15 red, Mig-17 repaint |
#19
|
||||
|
||||
Right side fuselage
Similar construction to the other twin fuselage. Only difference is that it house a nose gear bay.
I added a small piece of wood strip to support it. Isaac
__________________
My gallery [http://www.papermodelers.com/gallery...v-r-6&cat=500] Recent buildsMeteor F1, Meteor F8, Mig-Ye8, NA Sabre, A-4E Skyhawk,Mig-15 red, Mig-17 repaint |
#20
|
||||
|
||||
Hi Isaac, the aircraft looks a bit like drone up so far, without any canopy yet .
Regards, Erik |
Google Adsense |
Thread Tools | |
Display Modes | |
|
|