Hello Hayden0915,
Equal distance is fine. The wing does not go through the fuselage so spacing is not an issue. I used scraps of card stock to secure the formers to the spline so the formers wouldn't slide around and bunch up at one end of the fuselage. You are probably not going to rebuild the fuselage as many times as I did, sliding the former assembly out of the old fuselage and into the new fuselage over and over again. So, I think, you can simply glue the formers to the spline. By the way, you may have noticed that the cross section of the fuselage is one circle overlapping a slightly larger circle. The upper half is wider than the lower half. Please see the attached cabin cross section for more details. Hope this helps, Henry
|