|
|
|
#1
01-22-2017, 05:25 PM
|
|||
|
|||
|
PZL 7A 1/33rd from Marek
All,
I finally got printer issues solved with better colors (the B-24 looked cool) so I printed out this Marek design I bought from Andrey's e-shop. Looks like a nice kit to try with yet another way to do things. So here are just the "kit" parts!  I look forward to it. Cheers, Dan 
|
| Google Adsense |
|
#4
02-02-2017, 11:18 PM
|
|||
|
|||
|
All,
I got the main engine parts done. The pictures tell the tale. All the parts fit really nicely so far.    I'm going to try and detail the engine a bit more like i did on the J-22. This will be fun. Cheers, Dan
|
|
#5
02-22-2017, 04:36 PM
|
|||
|
|||
|
Well...since this last post, I started to put on the cowling and area just in front of the crank case, ONLY THEN realizing that you can't have the cylinders in place to do this! Do'h!!!
 I have since pulled them off and started the cowl etc. and it's looking ok. I'll post actual pictures tonight. Just a brief update! Dan
|
| Google Adsense |
|
#6
02-22-2017, 11:13 PM
|
|||
|
|||
|
So...here it is! The parts, so far, fit nicely. I was a bit afraid of the successive cowl rings since they were all simply butt joints. This terrified me. But, they fit great, are smooth and a tribute to the designer. My cuts must have been careful enough too. I just cut right along the lines (split 'em).
The only one that is a bit off for me was the rear-most wrap around the cowl. It left a gap at the bottom which I filled with extra paper. Not sure why this happened, as all the others fit really nicely and matched. Oh, well...    Now I hope rest goes together as well!  Cheers, Dan Last edited by smithdr; 02-22-2017 at 11:32 PM.
|
|
#9
02-25-2017, 08:22 AM
|
||||
|
||||
|
Very nice clean work. The detailing on the engine looks very nice, and a great looking pilot's office.
Gary
__________________
"Fast is fine, but accuracy is everything" - Wyatt Earp Design Group Alpha https://ecardmodels.com/vendors/design-group-alpha
|
|
#10
02-25-2017, 11:58 PM
|
|||
|
|||
|
Thanks, Folks. Here is the state of affairs tonight. I'm working very slowly but am trying to get my seams to look like Isaac's Fury! That is...seam-less.
Mine need work and I botched the left side of the head rest...but the right side is pretty good. I also folded tabs the CORRECT way (Thanks... ) and added the cockpit edging. The last shot shows the completion so far...   We'll see how far I can get tomorrow. Thanks for looking and have a great Sunday...Dan
|
| Google Adsense |
 |
|
|
I can't miss this one!
Linear Mode
